Donor Cornea Punches

Donor Cornea Punch
Other Products



Barron Donor Cornea Punches

The Barron Donor Cornea Punch is a disposable, single-use instrument for harvesting of donor corneal tissue for corneal keratoplasty procedures such as penetrating keratoplasty and the more recently-developed endothelial keratoplasty. The punch set is comprised of a nylon cutting block and a top that contains the cutting blade.  It is delivered with a plastic ring that protects the blade during shipment. The top, blade protector ring, and cutting block are held together with a silicone band, and the assembly is hermetically packaged in a pouch and sterilized with ethylene oxide.

Punch as shipped
Marking Donor Punch

The punch features a solid stainless steel blade that is permanently mounted in a nylon housing with four stainless steel guide posts to align with four corresponding holes in the cutting block. The guide posts, which are precision aligned with the blade,  accurately center the blade over the donor cornea as the tissue is cut.  The well of the cutting block has four small holes that may be inked with a sterile marking pen (included) to identify the four quadrants of the cornea for cardinal suture alignment in the recipient bed.

Punch Inking from Top

 The holes in the cutting block are located approximately 0.6 mm inside the edge of the cut that will be made by the blade.  The marking can either be done from the top of block prior to placement of the donor tissue (see left diagram), or preferably from the bottom after the donor tissue has been placed in the well of the cutting block and the top put in place (see right diagram).

Punch - Bottom Inked 

 The blade of the Barron Donor Cornea Punch is fabricated from the hardest stainless steel that is available, and its manufacture employs a proprietary, multiple-stage honing of the blade edge to give an unsurpassed sharpness. The blades in the BPI punches are 0.3 mm thick, which yields blades that are sturdy and less subject to accidental damage that might be caused by the surgeon or assistant during preparation for the operation.

If you have Adobe Flash installed as a plug-in, you can observe on the right an illustration of the punch as it would be used on a donor cornea. 



The Barron Donor Cornea Marking Punches come in 13 sizes, with blade diameters ranging from 6.0 mm to 9.5 mm.  There are two families of  vacuum trephines that can be used in conjunction with the donor punches: the Hessburg-Barron Vacuum Trephine and the Barron Radial Vacuum Trephine.

The Barron Donor Cornea Punches are sold only through Distributors.  They are  sold as the Barron Marking Donor Punch by JedMed Instruments and by Altomed (outside the U.S.). They are sold as the Barron Donor Cornea Punch by Katena Products. Contact one of these distributors to purchase these punches.

6.0 mm
6.5 mm
6.75 mm
7.0 mm
7.25 mm
7.5 mm
7.75 mm
8.0 mm
8.25 mm
8.5 mm 
8.75 mm 
9.0 mm 
9.5 mm 
10.0 mm